Overview

Please see the sections below for the MEMS 1.3 ECU

Diagnostic application - Windows/Mac/Linux

The most up to date application is here for Windows/Linux
Web/agent application

This is a web based application that works in Windows/Max/Linux computers or laptops
Web application

Diagnostic application - Android phone and tablet

The Android app works with MEMS 1.3 ECUs while using an appropriate cable.
The cables are full size USB so you will likely need to buy an "OTG" adaptor that fits between your device and the USB cable.
Android app in the Google Play store

Remapping

There is an online editor for ECU maps here: ROM Editor

These ECUs can be modified to allow remaps.
A chip socket is installed into the ECU so that a rewritable chip can be installed.
At the moment it is not possible to use an OBD cable for programming, the chip must be physically removed from the ECU each time and written by using a USB chip programmer.
This takes a good amount of time and should only be done by someone very experienced with soldering and PCB repair work.

1.3 ECU modified ROM chip board and socket

Technical information - diagnostic communication

In case you are a programmer or would like more info about communication with the ECUs for diagnostics, here it is

Connect at 9600 Baud rate, 8 bits, 1 stop bit, NO parity
"Normal" serial communication - ECU has a TX and RX pin, plus a signal ground

Shared data packet format with 1.2/1.3/1.6/1.9 ECUs, see The technical page